Sta-Rite 5P6R Swimming Pool Pump
The Sta-Rite 5P6R series pumps are designed for the higher volume semi-commercial or commercial installation.
Sta-Rite highly recommended the installation post pump of the serviceable check valve to inhibit impellor spin-off due to back pressures.
The pump can suction lift up to 4.5m and has 2" BSP Threaded intake & discharge for higher pumping volumes.
We have also included in the list an engineers secret tool called 'Magic Lube', this is a highly viscous long term silicone lubricant which is perfect for sealing the O-rings on unions, simply smear onto your o rings for a perfect seal. Can also be used on pump basket O-rings or filter lid O-rings.
Heavy Duty Motor
50 Hz motors are designed for continuous, quiet operation - feature stainless steel one piece shaft, sealed and permanently lubricated bearings - runs cooler for prolonged life under high ambient conditions
Self Priming Diffuser design makes this our fastest priming pool pump... incomparable!
"See Thru" trap lid
Eliminates all the guesswork - you see when the basket needs cleaning - designed to withstand 4 bar test pressure as well as high vacuum conditions. New Quick-Lock trap cover ring permits fast access to the strainer basket.
Exclusive "lock-in" 5" Diameter basket prevents large debris from clogging the impeller.
|Pump Power Conversions|
|0.25 Kw||0.33 HP|
|0.375 Kw||0.5 HP|
|0.55 Kw||0.75 HP|
|0.75 Kw||1.0 HP|
|1.12 Kw||1.5 HP|
|1.5 Kw||2.0 HP|
|2.25 Kw||3.0 HP|
Please note that most domestic pumps are Single Phase 240v pumps. Three Phase 415V pumps are very uncommon in a domestic environment. If you are unsure, you must check with your qualified Electrician who can advise you on your requirements.
The Pump is configured with 1 1/2" female parallel threads for both the horizontal intake and the vertical discharge.
We recommend you use P.T.F.E tape or LA-CO Slic-Tite to apply to the male thread on your pump unions. please order your unions if required from the pipework section. The 1 1/2" male threaded unions are ideal if you are connecting your remaining pipework with normal solvent weld fittings.
We also recommend the use of the Anti-vibration pad, as this allows the pump to be installed onto various floor surfaces with the added sound & vibration deadening benefit the pads give.
This Product has a 3 year warranty on the pump wet end, 2 year warranty on the pump motor and 1 year warranty on the mechanical seal.
Please note that all pumps are factory wet tested, so a small amount of water may still be present in the pump.
Warranty will be void if damage is due to chemical or sand/grit damage to the seals of this pump. This pump cannot be run dry as this WILL damage the shaft seal.
Not recommended for use with water that is chemically treated with Salt, Bromine or Aquabrome products as these are considerably more corrosive.