Hayward Super Pump
Super Pump - The high performance pump.
Efficiency, reliability, longevity...the Super Pump has everything you need and have come to expect from a Hayward Pump.
It is ideal for replacing an existing pump or for a new installation.
Old Hayward Code to NEW Hayward Code
0.75HP - Old: SP1608XE111 New: SP1608XW111
1HP - Old: SP1611XE161 New: SP1611XW161
1.5HP - Old: SP1616XE221 New: SP2616XW221
2HP - Old: SP1622XE251 New: SP2622XW251
NEW Code SP1 = 1.5"
NEW Code SP2 = 2"
The Super Pump is a "safe bet".
High performance: Noryl® impeller
Resists chemical and saline corrosion under normal use conditions.
Silent: low sound emission
Economical: low electricity consumption.
Resistant engine with high output.
Delivery: up to 19.8 m³/h
Head: up to 13.5 m
Power supply: single & three phase 50 Hz
Power: from 0.56 kW up to 1.5 kW
Maximum operating pressure: 2 bar
Temperature of pumped liquid: from 0 °C to 40 °C
|Pump Power Conversions|
|0.25 Kw||0.33 HP|
|0.375 Kw||0.5 HP|
|0.55 Kw||0.75 HP|
|0.75 Kw||1.0 HP|
|1.12 Kw||1.5 HP|
|1.5 Kw||2.0 HP|
|2.25 Kw||3.0 HP|
Please Note that the 0.75hp pump is only available in single phase.
Please note that most domestic pumps are Single Phase 240v pumps. Three Phase 415V pumps are very uncommon in a domestic environment. If you are unsure, you must check with your qualified Electrician who can advise you on your requirements.
The Pump is configured with internal 1 1/2" female parallel threads for both the horizontal intake and the vertical discharge. (2hp pump is 2" female)
We recommend you use P.T.F.E tape or LA-CO Slic-Tite to apply to the male thread on your pump unions. please order your unions if required from the pipework section. The 1 1/2" male threaded unions are ideal if you are connecting your remaining pipework with normal solvent weld fittings.
We also recommend the use of the Anti-vibration pad, as this allows the pump to be installed onto various floor surfaces with the added sound & vibration deadening benefit the pads give.
This Product has a 2 year warranty on the pump wet end, 2 year warranty on the pump motor and 1 year warranty on the mechanical seal.
Please note that all pumps are factory wet tested, so a small amount of water may still be present in the pump.
Warranty will be void if damage is due to chemical or sand/grit damage to the seals of this pump. This pump cannot be run dry as this WILL damage the shaft seal.